A few days back one of my clients had doubts whether the port he required was forwarded correctly on the FGT.
I assured him it was and asked him to check with his IT teams whether the port was accepting traffic on the server locally, I guess many people get confused that for port forwarding to work correctly the port in question should also be open on the server or the application. These people were using Tomcat7.
Since his other IT team wasn’t convinced I decided to just send him a log of the debug from FGT.
Here’s the debug command to check this.
diag debug enable
diag debug flow filter dport 80(the destination port which you have configured in VIP)
diag debug flow filter saddr
diag debug flow show console enable
diag debug flow trace start 100(this I guess is the number of packets or hits..will have to look this up)
<Your public IP address> I say public because when you would be sending traffic to this FGT to generate the debug logs, your incoming traffic will have the source IP of your wan which is aka your public IP. I’m sure someone out there is getting no logs at all because he’s gone all ipconfig and added his 192.168… in there which is the internal LAN network IP aka your private address.
To clear the debug filters use
diag debug reset
diad debug disable
diag debug flow filter clear
You should clear the filters every time before running the debug again.
Once your debug commands are in, just go through your browser and access the FGT’s IP as
http://x.x.x.x:yy where yy is the forwarded port, for eg: 8080, 8888, 3389 and so on. I was working with the simple port 80 so all i needed to do was http://x.x.x.x as http uses port 80.
The debug generated is as follows:
BSH # id=36871 trace_id=525 msg=”vd-root received a packet(proto=6, z.z.z.z:52957->x.x.x.x:80) from wan2.”
id=36871 trace_id=525 msg=”allocate a new session-0036f1c2″
id=36871 trace_id=525 msg=”find SNAT: IP-220.127.116.11(from IPPOOL), port-80″
id=36871 trace_id=525 msg=”VIP-18.104.22.168:80, outdev-wan2″
id=36871 trace_id=525 msg=”DNAT x.x.x.x:80->22.214.171.124:80″
id=36871 trace_id=525 msg=”find a route: gw-126.96.36.199 via internal”
id=36871 trace_id=525 msg=”Allowed by Policy-2:”
Again x.x.x.x is the target FGT’s public IP and z.z.z.z is my public IP from where I sent the traffic to generate the logs.
I swear this is the easiest to understand debug output ever. Everything is just right there.